Machine start-up and cleaning operations
Machine start-up (1)
- Start processing by opening a bag of material on the hopper and disconnecting the hose that brings water to the mixing chamber [2].
- Press and hold the water integration button [5], set the flow meter [4] to about 700-800 l/h via the tap [1] and then reconnect the hose [2].
- Press the water integration button [5] for ± 3 seconds to add water to the mixing chamber.
- Press the green button [6] to start the mortar pump.
Machine start-up (2)
.png)
Move the cell wheel selector [1] repeatedly as follows:
- 2 seconds “On”
- 2 seconds “Off”
- 2 seconds “On”
- 2 seconds “Off”
- Leave the selector on “On”
Adjust the amount of water using the tap [3] until the correct consistency of the material is obtained.
Keep the hopper always full.
Machine start-up (3) - Warnings
- ALWAYS keep the hopper loaded while pumping.
- Secure the pump assembly securely.
- Never open the connections of the pressure hoses.
- Do not work with long hose lines to preserve the life of the auger and stator.
Cleaning operations (1)
- Stop the cell wheel [1].
- When water comes out of the gun, stop the mortar pump [2].
- Disconnect the gun and clean it thoroughly, removing the deflector.
- Check that the air nozzle hole is clear (if necessary, clean it using the cleaning tool provided).
Cleaning operations (2)
- Disconnect the material hose and insert a washing sponge into the hose.
- Connect the special fitting supplied [3] to the auxiliary tap [2] and the hose [4].
- Open the auxiliary tap [1].
- Restart the machine via the main switch and wash the pipes.
Cleaning operations (3)
- Open the mixing chamber [3] and remove the mixer [2].
- Insert the scraper [1] and close the mixing chamber [3].
- Start the mortar pump.
- After approximately 30 seconds, switch off the mortar pump.
- Reinsert the mixer [2] and set the main switch to “0”.
Cleaning operations (4) - Warnings
- The sponge may be violently ejected from the hose, so make sure the hose is pointing in a direction where there is no risk of injury or damage to property.*
- Never hold the end hose in your hands during cleaning, it is advisable to secure it firmly to a support.*
- If the pipes become blocked, the sponge will not be ejected immediately.*
- Before loosening any joints, make sure the pressure gauge indicates zero pressure and that there is no residual pressure in the pipes.*
* Always refer to the manual supplied with the machine for complete and detailed safety instructions