Starting in electric mode
Starting in electric mode (1)
-
Disconnect the battery by turning the battery switch located in the engine compartment of the machine;
- Remove the protective cap from the socket and connect the power cable with the plug.
Starting in electric mode (2)
To power up and start the TSR7, with an electric motor, proceed as follows:
- Make sure that the red emergency buttons are not pressed;
- Activate the main switch of the electrical panel (C56), making sure that the yellow light (S15) is off;*
*If it is on, invert two phases by intervening on the cable
Starting in electric mode (3)
- Insert the key into the key selector on the control panel;
- Turn the key selector to the first stable position to power the machine's CPU;
- The control keys light up in quick sequence to indicate the machine's start-up status.
Starting in electric mode (4)
- Make sure that, after a few seconds during which the CPU performs its start-up and control functions, the mains power light is on (0);
- Press the button (6) of the electric motor and hold it down for more than two seconds.
- The electric motor will then start and the button will light up red.
Starting in electric mode (5)
-
When the electric motor is on, pressing the button (6) will turn it off.
For safety reasons, after switching off, the electric motor cannot be restarted before five seconds have passed.
- When the electric motor is switched off, the red light on the button (6) will switch off.
Warning: Always check that the motor is rotating in the correct direction. If not, switch it off immediately to avoid damaging the hydraulic system.